Cisco NCS 6000 Series

configure
router static
address-family ipv4 unicast
0.0.0.0/0 2.6.0.1 110
end
Configuring a Floating Static Route: Example
A floating static route is often used to provide a backup path if connectivity fails. In the following example,
a route is configured with an administrative distance of 201.
configure
router static
address-family ipv6 unicast
2001:0DB8::/32 2001:0DB8:3000::1 201
end
Where to Go Next
For additional information about static routes, routing protocols, and RIB, consult the following publications:
• Implementing and Monitoring RIB on Cisco IOS XR Software in Routing Configuration Guide for Cisco
NCS 6000 Series Routers
• Implementing BGP on Cisco IOS XR Software in Routing Configuration Guide for Cisco NCS 6000
Series Routers
• Implementing EIGRP on Cisco IOS XR Software in Routing Configuration Guide for Cisco NCS 6000
Series Routers
• Implementing IS-IS on Cisco IOS XR Software in Routing Configuration Guide for Cisco NCS 6000
Series Routers
• Implementing OSPF on Cisco IOS XR Software in Routing Configuration Guide for Cisco NCS 6000
Series Routers
• Implementing OSPFv3 on Cisco IOS XR Software in Routing Configuration Guide for Cisco NCS 6000
Series Routers
• RIB Commands on Cisco IOS XR Software in Routing Command Reference for Cisco NCS 6000 Series
Routers
• Implementing RIP on Cisco IOS XR Software in Routing Configuration Guide for Cisco NCS 6000 Series
Routers
Additional References
The following sections provide references related to implementing Static Routes.
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
471
Implementing Static Routes
Configuring a Floating Static Route: Example