Cisco NCS 6000 Series User Manual

BFD over MPLS TE Tunnel Tail-end Configuration: Example
This example shows how to configure BFD over MPLS TE Tunnels at tail-end.
bfd multipath include loc 0/1/CPU0
mpls oam
mpls traffic-eng bfd lsp tail multiplier 3
mpls traffic-eng bfd lsp tail minimum-interval 100
Where to Go Next
BFD is supported over multiple platforms. For more detailed information about these commands, see the
related chapters in the corresponding Cisco IOS XR Routing Command Reference and Cisco IOS XR MPLS
Command Reference for your platform at:
http://www.cisco.com/en/US/products/ps5845/prod_command_reference_list.html
• BGP Commands on Cisco IOS XR Software
• IS-IS Commands on Cisco IOS XR Software
• OSPF Commands on Cisco IOS XR Software
• Static Routing Commands on Cisco IOS XR Software
• MPLS Traffic Engineering Commands on Cisco IOS XR Software
Additional References
The following sections provide references related to implementing BFD for Cisco IOS XR software.
Related Documents
Document TitleRelated Topic
Routing Command Reference for Cisco NCS 6000
Series Routers
BFD commands: complete command syntax,
command modes, command history, defaults, usage
guidelines, and examples
Configuring QoS packet classification
Standards
TitleStandards
—No new or modified standards are supported by this
feature, and support for existing standards has not
been modified by this feature.
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
176
Implementing BFD
BFD over MPLS TE Tunnel Tail-end Configuration: Example

Cisco NCS 6000 Series Specifications

General

Brand	Cisco
Model	NCS 6000 Series
Category	Network Router
Language	English