EasyManuals Logo

Cisco NCS 6000 Series User Manual

Cisco NCS 6000 Series
498 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #221 background imageLoading...
Page #221 background image
summary-address 10.0.0.0 255.255.0.0
!
Configuring an EIGRP Stub Operation: Example
The following example shows how to configure an EIGRP stub. Stub operation allows only connected, static,
and summary routes to be advertised to neighbors.
router eigrp 200
address-family ipv4
stub connected static summary
router-id 172.16.82.22
log-neighbor-changes
log-neighbor-warnings
redistribute connected route-policy CONN_POLICY
interface GigabitEthernet0/6/0/0
passive-interface
neighbor 10.0.0.31
!
interface GigabitEthernet0/6/0/1
passive-interface
neighbor 10.0.1.21
!
!
!
Additional References
The following sections provide references related to implementing EIGRP.
Related Documents
Document TitleRelated Topic
Routing Command Reference for Cisco NCS 6000
Series Routers
EIGRP commands: complete command syntax,
command modes, command history, defaults, usage
guidelines, and examples
Implementing MPLS Traffic Engineering on module
in MPLS Configuration Guide for Cisco NCS 6000
Series Routers
Site of Origin (SoO) support for EIGRP feature
information
Standards
TitleStandards
—No new or modified standards are supported by this feature, and support for existing standards has not
been modified by this feature.
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
199
Implementing EIGRP
Configuring an EIGRP Stub Operation: Example

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco NCS 6000 Series and is the answer not in the manual?

Cisco NCS 6000 Series Specifications

General IconGeneral
BrandCisco
ModelNCS 6000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals