Cisco NCS 6000 Series User Manual

PurposeCommand or Action
Specifies the autonomous system number of the routing
process to configure an EIGRP routing process.
router eigrp as-number
Example:
Step 2
RP/0/RP0/CPU0:router(config)# router eigrp 100
Enters an address family configuration mode.address-family { ipv4 }
Example:
Step 3
RP/0/RP0/CPU0:router(config-eigrp)# address-family
ipv4
Configures a router as a stub for EIGRP.stub [ receive-only | {[ connected ] [ redistributed ] [
static ] [ summary ]}]
Step 4
Example:
RP/0/RP0/CPU0:router(config-eigrp-af)# stub
receive-only
commit
Step 5
Verifies that a remote router has been configured as a stub
router with EIGRP.
show eigrp [ ipv4 ] neighbors [ as-number ] [ detail ]
[ type interface-path-id | static ]
Step 6
Example:
The last line of the output shows the stub status of the
remote or spoke router.
RP/0/RP0/CPU0:router# show eigrp neighbors detail
Monitoring EIGRP Routing
The commands in this section are used to log neighbor adjacency changes, monitor the stability of the routing
system, and help detect problems.
SUMMARY STEPS
1. configure
2. router eigrp as-number
3. address-family [ ipv4 | ipv6 ]
4. log-neighbor-changes
5. log-neighbor-warnings
6. commit
7. clear eigrp [ as-number ] [ ipv4 | ipv6 ] neighbors [ ip-address | type interface-path-id ]
8. clear eigrp [ as-number ] [ ipv4 | ipv6 ] topology [ prefix mask ] [ prefix / length ]
9. show eigrp [ as-number ] [ ipv4 | ipv6 ] interfaces [ type interface-path-id ] [ detail ]
10. show eigrp [ as-number ] [ ipv4 | ipv6 ] neighbors [ detail ] [ type interface-path-id | static ]
11. show protocols eigrp
12. show eigrp [ as-number ] [ ipv4 | ipv6 ] topology [ ip-address mask ] [ active | all-links |
detail-links | pending | summary | zero-successors ]
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
196
Implementing EIGRP
Monitoring EIGRP Routing

Cisco NCS 6000 Series Specifications

General

Brand	Cisco
Model	NCS 6000 Series
Category	Network Router
Language	English