EasyManuals Logo

Cisco NCS 6000 Series User Manual

Cisco NCS 6000 Series
498 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #480 background imageLoading...
Page #480 background image
10.0.0.0/8 le 32,
172.16.0.0/12 le 32,
192.168.0.0/16 le 32
end-set
route-policy inbound-tx
if destination in too-specific or destination in rfc1918 then
drop
endif
set med 1000
set local-preference 90
set community (2:1001) additive
if community matches-any ([101..106]:202) then
prepend as-path 2.30 2
set community (2:666) additive
if med is 666 or med is 225 then
set origin incomplete
else
set origin igp
endif
else
set community (2:999) additive
endif
end-policy
router bgp 2
neighbor 10.0.1.2 address-family ipv4 unicast route-policy inbound-tx in
Modular Inbound Policy: Example
The following policy example shows how to build two inbound policies, in-100 and in-101, for two different
peers. In building the specific policies for those peers, the policy reuses some common blocks of policy that
may be common to multiple peers. It builds a few basic building blocks, the policies common-inbound,
filter-bogons, and set-lpref-prepend.
The filter-bogons building block is a simple policy that filters all undesirable routes, such as those from the
RFC 1918 address space. The policy set-lpref-prepend is a utility policy that can set the local preference and
prepend the AS path according to parameterized values that are passed in. The common-inbound policy uses
these filter-bogons building blocks to build a common block of inbound policy. The common-inbound policy
is used as a building block in the construction of in-100 and in-101 along with the set-lpref-prepend building
block.
This is a simple example that illustrates the modular capabilities of the policy language.
prefix-set bogon
10.0.0.0/8 ge 8 le 32,
0.0.0.0,
0.0.0.0/0 ge 27 le 32,
192.168.0.0/16 ge 16 le 32
end-set
!
route-policy in-100
apply common-inbound
if community matches-any ([100..120]:135) then
apply set-lpref-prepend (100,100,2)
set community (2:1234) additive
else
set local-preference 110
endif
if community matches-any ([100..666]:[100..999]) then
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
458
Implementing Routing Policy
Modular Inbound Policy: Example

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco NCS 6000 Series and is the answer not in the manual?

Cisco NCS 6000 Series Specifications

General IconGeneral
BrandCisco
ModelNCS 6000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals