Cisco NCS 6000 Series User Manual

PurposeCommand or Action
RP/0/RP0/CPU0:router(config-ospfv3)#spf
prefix-priority route-policy ospf3-spf-priority
commit
Step 6
Displays the set SPF prefix priority.
show rpl route-policy route-policy name detail
Example:
Step 7
RP/0/RP0/CPU0:router#show rpl route-policy
ospf-spf-priority detail
prefix-set ospf-critical-prefixes
66.0.0.0/16
end-set
!
route-policy ospf-spf-priority
if destination in ospf-critical-prefixes then
set spf-priority critical
endif
end-policy
!
Configuring Multi-area Adjacency
This task explains how to create multiple areas on an OSPF primary interface.
Before you begin
You can configure multi-area adjacency on any interface where only two OSF speakers are attached. In the
case of native broadcast networks, the interface must be configured as an OPSF point-to-point type using the
network point-to-point command to enable the interface for a multi-area adjacency.
Note
SUMMARY STEPS
1. configure
2. router ospf process-name
3. area area-id
4. interface type interface-path-id
5. area area-id
6. multi-area-interface type interface-path-id
7. commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
312
Implementing OSPF
Configuring Multi-area Adjacency

Cisco NCS 6000 Series Specifications

General

Brand	Cisco
Model	NCS 6000 Series
Category	Network Router
Language	English