Cisco NCS 6000 Series

nsf
auto-cost reference-bandwidth 10000
mpls traffic-eng router-id Loopback 0
area 0
mpls traffic-eng
interface GigabitEthernet 0/2/0/0
interface Loopback 0
ABR with Summarization for OSPFv3: Example
The following example shows the prefix range 2300::/16 summarized from area 1 into the backbone:
router ospfv3 1
router-id 192.168.0.217
area 0
interface GigabitEthernet 0/2/0/1
area 1
range 2300::/16
interface GigabitEthernet 0/2/0/0
ABR Stub Area for OSPFv3: Example
The following example shows that area 1 is configured as a stub area:
router ospfv3 1
router-id 10.0.0.217
area 0
interface GigabitEthernet 0/2/0/1
area 1
stub
interface GigabitEthernet 0/2/0/0
ABR Totally Stub Area for OSPFv3: Example
The following example shows that area 1 is configured as a totally stub area:
router ospfv3 1
router-id 10.0.0.217
area 0
interface GigabitEthernet 0/2/0/1
area 1
stub no-summary
interface GigabitEthernet 0/2/0/0
Configuring OSPF SPF Prefix Prioritization: Example
This example shows how to configure /32 prefixes as medium-priority, in general, in addition to placing some
/32 and /24 prefixes in critical-priority and high-priority queues:
prefix-set ospf-critical-prefixes
192.41.5.41/32,
11.1.3.0/24,
192.168.0.44/32
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
337
Implementing OSPF
ABR with Summarization for OSPFv3: Example