Cisco NCS 6000 Series

Cached backup adjacency
Cached backup num. entries : 1
protected num. entries : 1
backup is a tunnel : yes
backup tunnel local label : 16007
remote LFA active: 1
Shared TLU Channel: 4 Addr: 0x300a02
Entry[0]
[HW: 0x00000004 0x00000086 0x01280480 0x00070000]
dest. addr : 0x4
sponge queue : 134
egress port : 0x128048
rp destined : no
service destined : no
rp drop : no
hash type : 0
uidb index : 0x7
Load distribution: 0 (refcount 3)
Hash OK Interface Address
0 Y TenGigE0/2/0/4 180.4.0.2
Configuring IS-IS Overload Bit Avoidance
This task describes how to activate IS-IS overload bit avoidance.
Before you begin
The IS-IS overload bit avoidance feature is valid only on networks that support the following Cisco IOS XR
features:
• MPLS
• IS-IS
SUMMARY STEPS
1. configure
2. mpls traffic-eng path-selection ignore overload
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Activates IS-IS overload bit avoidance.mpls traffic-eng path-selection ignore overload
Example:
Step 2
RP/0/RP0/CPU0:router(config)# mpls traffic-eng
path-selection ignore overload
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
247
Implementing IS-IS
Configuring IS-IS Overload Bit Avoidance