Cisco NCS 6000 Series User Manual

Disabling Echo Mode on an Individual Interface
The following procedures describe how to disable echo mode on an interface .
SUMMARY STEPS
1. configure
2. bfd
3. interface type interface-path-id
4. echo disable
5. commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters BFD configuration mode.bfd
Example:
Step 2
RP/0/RP0/CPU0:router(config)# bfd
Enters BFD interface configuration mode for a specific
interface or bundle. In BFD interface configuration mode,
interface type interface-path-id
Example:
Step 3
you can disable echo mode on an individual interface or
bundle.
RP/0/RP0/CPU0:router(config-bfd)# interface
gigabitEthernet 0/1/5/0
Disables echo mode on the specified individual interface
or bundle.
echo disable
Example:
Step 4
RP/0/RP0/CPU0:router(config-bfd-if)# echo disable
commit
Step 5
Minimizing BFD Session Flapping Using BFD Dampening
To configure BFD dampening to control BFD session flapping, complete the following steps.
SUMMARY STEPS
1. configure
2. bfd
3. dampening [bundle-member] {initial-wait | maximum-wait | secondary-wait} milliseconds
4. commit
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
157
Implementing BFD
Disabling Echo Mode on an Individual Interface

Cisco NCS 6000 Series Specifications

General

Brand	Cisco
Model	NCS 6000 Series
Category	Network Router
Language	English