CHAPTER 10
Implementing RIP
The Routing Information Protocol (RIP) is a classic distance vector Interior Gateway Protocol (IGP) designed
to exchange information within an autonomous system (AS) of a small network.
This module describes the concepts and tasks to implement basic RIP routing. Cisco IOS XR software supports
a standard implementation of RIP Version 2 (RIPv2) that supports backward compatibility with RIP Version
1 (RIPv1) as specified by RFC 2453.
For more information about RIP on the Cisco IOS XR software and complete descriptions of the RIP commands
listed in this module, see the Related Documents, on page 379 section of this module. To locate documentation
for other commands that might appear while performing a configuration task, search online in the .
Note
Feature History for Implementing RIP
This feature was introduced.Release
5.0.0
• Prerequisites for Implementing RIP, on page 365
• Information About Implementing RIP, on page 366
• How to Implement RIP, on page 371
• Configuration Examples for Implementing RIP, on page 377
• Additional References, on page 379
Prerequisites for Implementing RIP
You must be in a user group associated with a task group that includes the proper task IDs. The command
reference guides include the task IDs required for each command. If you suspect user group assignment is
preventing you from using a command, contact your AAA administrator for assistance.
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
365
To Next Page
Loading...
Need help?
General
