EasyManuals Logo

Cisco NCS 6000 Series User Manual

Cisco NCS 6000 Series
498 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #393 background imageLoading...
Page #393 background image
ThenIf...
The RIP packet passes authentication check at the
remote/peer end, provided the remote router is also
configured to authenticate the packets using the same
keychain.
The keychain configured on the RIP interface exists
in the keychain database ...
The RIP packet passes authentication check at the
remote/peer end, provided the remote router is also
configured to authenticate the packets using the same
keychain.
The keychain is configured with a MD5 cryptographic
algorithm...
Else, RIP packets fail authentication check.
How to Implement RIP
This section contains instructions for the following tasks:
To save configuration changes, you must commit changes when the system prompts you.
Note
Enabling RIP
This task enables RIP routing and establishes a RIP routing process.
Before you begin
Although you can configure RIP before you configure an IP address, no RIP routing occurs until at least one
IP address is configured.
SUMMARY STEPS
1. configure
2. router rip
3. neighbor ip-address
4. broadcast-for-v2
5. interface type interface-path-id
6. receive version { 1 | 2 | 1 2 }
7. send version { 1 | 2 | 1 2 }
8. commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
371
Implementing RIP
How to Implement RIP

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco NCS 6000 Series and is the answer not in the manual?

Cisco NCS 6000 Series Specifications

General IconGeneral
BrandCisco
ModelNCS 6000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals