Cisco NCS 6000 Series User Manual

DETAILED STEPS
PurposeCommand or Action
Displays route summary information about the specified
routing table.
show route ipv4 | ipv6 ] [ unicast ]
Example:
Step 1
• The default table summarized is the IPv4 unicast
routing table.
RP/0/RP0/CPU0:router# show route summary
Displays more detailed route information about the specified
routing table.
show route ipv4 | ipv6 ] [ unicast ]
Example:
Step 2
• This command is usually issued with an IP address or
other optional filters to limit its display. Otherwise, it
RP/0/RP0/CPU0:router# show route ipv4 unicast
displays all routes from the default IPv4 unicast routing
table, which can result in an extensive list, depending
on the configuration of the network.
Disabling RIB Next-hop Dampening
Perform this task to disable RIB next-hop dampening.
SUMMARY STEPS
1. router rib
2. address-family { ipv4 | ipv6 } next-hop dampening disable
3. commit
DETAILED STEPS
PurposeCommand or Action
Enters RIB configuration mode.router rib
Example:
Step 1
RP/0/RP0/CPU0:router# route rib
Disables next-hop dampening for IPv4 address families.address-family { ipv4 | ipv6 } next-hop dampening
disable
Step 2
Example:
RP/0/RP0/CPU0:router(config-rib)# address family
ipv4 next-hop dampening disable
commit
Step 3
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
358
Implementing and Monitoring RIB
Disabling RIB Next-hop Dampening

Cisco NCS 6000 Series Specifications

General

Brand	Cisco
Model	NCS 6000 Series
Category	Network Router
Language	English