Cisco NCS 6000 Series

• Diagnostics—additional (debug) information collection for 'abnormal' events.
Configuring Route Convergence Monitoring and Diagnostics
Perform these tasks to configure route convergence monitoring and diagnostics:
SUMMARY STEPS
1. configure
2. router-convergence
3. collect-diagnostics location
4. event-buffer-size number
5. max-events-stored number
6. monitoring-interval minutes
7. node node-name
8. protocol
9. priority
10. disable
11. leaf-network number
12. threshold value
13. storage-location
14. diagnostics directory-path-name
15. diagnostics-size
16. reports directory-path-name
17. reports-size
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters configure Router Convergence Monitoring and
Diagnostics (rcmd) configuration mode.
router-convergence
Example:
Step 2
RP/0/RP0/CPU0:router(config)#router-convergence
Configures to collect diagnostics on specified node.
collect-diagnostics location
Example:
Step 3
RP/0/RP0/CPU0:router(config-rcmd)#collect-diagnostics
0/3/CPU0
Sets event buffer size 9as number of events) for storing
event traces .
event-buffer-size number
Example:
Step 4
RP/0/RP0/CPU0:router(config-rcmd)#event-buffer-size
100
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
474
Implementing RCMD
Configuring Route Convergence Monitoring and Diagnostics