Cisco NCS 6000 Series User Manual

set med 444
set local-preference 200
set community (no-export) additive
endif
end-policy
!
route-policy in-101
apply common-inbound
if community matches-any ([101..200]:201) then
apply set-lpref-prepend(100,101,2)
set community (2:1234) additive
else
set local-preference 125
endif
end-policy
!
route-policy filter-bogons
if destination in bogon then
drop
else
pass
endif
end-policy
!
route-policy common-inbound
apply filter-bogons
set origin igp
set community (2:333)
end-policy
!
route-policy set-lpref-prepend($lpref,$as,$prependcnt)
set local-preference $lpref
prepend as-path $as $prependcnt
end-policy
Use Wildcards For Routing Policy Sets
This section describes examples of configuring routing policy sets with wildcards.
Use Wildcards for Prefix Sets
Use the following example to configure a routing policy with wildcards for prefix sets.
1. Configure the required prefix sets in the global configuration mode.
RP/0/RP0/CPU0:router(config)# prefix-set pfx_set1
RP/0/RP0/CPU0:router(config-pfx)# 1.2.3.4/32
RP/0/RP0/CPU0:router(config-pfx)# end-set
RP/0/RP0/CPU0:router(config)# prefix-set pfx_set2
RP/0/RP0/CPU0:router(config-pfx)# 2.2.2.2/32
RP/0/RP0/CPU0:router(config-pfx)# end-set
2. Configure a route policy with wildcards to refer to the prefix sets.
RP/0/RP0/CPU0:router(config)# route-policy WILDCARD_PREFIX_SET
RP/0/RP0/CPU0:router(config-rpl)# if destination in prefix-set* then pass else drop endif
RP/0/RP0/CPU0:router(config-rpl)# end-policy
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
459
Implementing Routing Policy
Use Wildcards For Routing Policy Sets

Cisco NCS 6000 Series Specifications

General

Brand	Cisco
Model	NCS 6000 Series
Category	Network Router
Language	English