Cisco NCS 6000 Series

4. commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enables OSPF routing for the specified routing process and
places the router in router configuration mode.
router ospf process-name
Example:
Step 2
The process-name argument is any
alphanumeric string no longer than 40 characters.
Note
RP/0/RP0/CPU0:router(config)# router ospf 1
Enables LDP IGP interface auto-configuration for an OSPF
instance.
mpls ldp auto-config
Example:
Step 3
• Optionally, this command can be configured for an
area of an OSPF instance.
RP/0/RP0/CPU0:router(config-ospf)# mpls ldp
auto-config
commit
Step 4
Configuring LDP IGP Synchronization: OSPF
Perform this task to configure LDP IGP Synchronization under OSPF.
By default, there is no synchronization between LDP and IGPs.
Note
SUMMARY STEPS
1. configure
2. router ospf process-name
3. Use one of the following commands:
• mpls ldp sync
• area area-id mpls ldp sync
• area area-id interface name mpls ldp sync
4. commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Identifies the OSPF routing process and enters OSPF
configuration mode.
router ospf process-name
Example:
Step 2
RP/0/RP0/CPU0:router(config)# router ospf 100
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
314
Implementing OSPF
Configuring LDP IGP Synchronization: OSPF