EasyManuals Logo

Cisco NCS 6000 Series User Manual

Cisco NCS 6000 Series
498 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
PurposeCommand or Action
• send-extended-community-ebgp
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr-af)#
send-community-ebgp
or
RP/0/RP0/CPU0:router(config-bgp-nbr-af)#
send-extended-community-ebgp
commit
Step 7
Configuring the BGP Cost Community
Perform this task to configure the BGP cost community.
BGP receives multiple paths to the same destination and it uses the best-path algorithm to decide which is the
best path to install in RIB. To enable users to determine an exit point after partial comparison, the cost
community is defined to tie-break equal paths during the best-path selection process.
SUMMARY STEPS
1. configure
2. route-policy name
3. set extcommunity cost { cost-extcommunity-set-name | cost-inline-extcommunity-set } [ additive ]
4. end-policy
5. router bgp as-number
6. Do one of the following:
• default-information originate
• aggregate-address address/mask-length [ as-set ] [ as-confed-set ] [ summary-only ] [ route-policy
route-policy-name ]
• address-family { ipv4 | ipv6 } unicast redistribute connected [ metric metric-value ] [
route-policy route-policy-name ]
• address-family { ipv4 | ipv6 } unicast redistribute eigrp process-id [ match { external |
internal }] [ metric metric-value ] [ route-policy route-policy-name ]
• address-family { ipv4 | ipv6 } unicast redistribute isis process-id [ level { 1 | 1-inter-area
| 2 }] [ metric metric-value ] [ route-policy route-policy-name ]
• address-family { ipv4 | ipv6 } unicast redistribute ospf process-id [ match { external [ 1
| 2 ] | internal | nssa-external [ 1 | 2 ]}] [ metric metric-value ] [ route-policy
route-policy-name ]
7. Do one of the following:
• address-family { ipv4 | ipv6 } unicast redistribute ospfv3 process-id [ match { external
[ 1 | 2 ] | internal | nssa-external [ 1 | 2 ]}] [ metric metric-value ] [ route-policy
route-policy-name ]
• address-family { ipv4 | ipv6 } unicast redistribute rip [ metric metric-value ] [ route-policy
route-policy-name ]
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
72
Implementing BGP
Configuring the BGP Cost Community

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco NCS 6000 Series and is the answer not in the manual?

Cisco NCS 6000 Series Specifications

General IconGeneral
BrandCisco
ModelNCS 6000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals