Cisco NCS 6000 Series

• neighbor ipv6-link-local-address [ priority number ] [ poll-interval seconds ][ cost number
] [ database-filter [ all ]]
14. Repeat Step 13 for all neighbors on the interface.
15. commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enables OSPF routing for the specified routing process
and places the router in router configuration mode.
Do one of the following:
Step 2
• router ospf process-name
or
• router ospfv3 process-name
Enables OSPFv3 routing for the specified routing process
and places the router in router ospfv3 configuration mode.
Example:
RP/0/RP0/CPU0:router(config)# router ospf 1
The process-name argument is any
alphanumeric string no longer than 40
characters.
Note
or
RP/0/RP0/CPU0:router(config)# router ospfv3 1
Configures a router ID for the OSPF process.
router-id { router-id }
Step 3
Example:
We recommend using a stable IP address as the
router ID.
Note
RP/0/RP0/CPU0:router(config-ospf)# router-id
192.168.4.3
Enters area configuration mode and configures an area for
the OSPF process.
area area-id
Example:
Step 4
• The example configures a backbone area.
RP/0/RP0/CPU0:router(config-ospf)# area 0
• The area-id argument can be entered in
dotted-decimal or IPv4 address notation, such as area
1000 or area 0.0.3.232. However, you must choose
one form or the other for an area. We recommend
using the IPv4 address notation.
Configures the OSPF network type to a type other than
the default for a given medium.
network { broadcast | non-broadcast | {
point-to-multipoint [ non-broadcast ] | point-to-point
}}
Step 5
• The example sets the network type to NBMA.
Example:
RP/0/RP0/CPU0:router(config-ospf-ar)# network
non-broadcast
(Optional) Sets the time to wait for a hello packet from a
neighbor before declaring the neighbor down.
dead-interval seconds
Example:
Step 6
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
285
Implementing OSPF
Configuring Neighbors for Nonbroadcast Networks