Cisco NCS 6000 Series User Manual

4. timers basic update invalid holddown flush
5. output-delay delay
6. nsf
7. interface type interface-path-id
8. metric-zero-accept
9. split-horizon disable
10. poison-reverse
11. commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Configures a RIP routing process.router rip
Example:
Step 2
RP/0/RP0/CPU0:router(config)# router rip
(Optional) Enables automatic route summarization of
subnet routes into network-level routes.
auto-summary
Example:
Step 3
• By default, auto-summary is disabled.
RP/0/RP0/CPU0:router(config-rip)# auto-summary
If you have disconnected subnets, use the no
keyword to disable automatic route
summarization and permit software to send
subnet and host routing information across
classful network boundaries.
Note
(Optional) Adjusts RIP network timers.
timers basic update invalid holddown flush
Step 4
Example:
To view the current and default timer values,
view output from the show rip command.
Note
RP/0/RP0/CPU0:router(config-rip)# timers basic 5
15 15 30
(Optional) Changes the interpacket delay for the RIP
updates sent.
output-delay delay
Example:
Step 5
Use this command if you have a high-end router
sending at high speed to a low-speed router that
might not be able to receive at that fast a rate.
Note
RP/0/RP0/CPU0:router(config-rip)# output-delay 10
(Optional) Configures NSF on RIP routes after a RIP
process shutdown or restart.
nsf
Example:
Step 6
RP/0/RP0/CPU0:router(config-rip)# nsf
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
373
Implementing RIP
Customizing RIP

Cisco NCS 6000 Series Specifications

General

Brand	Cisco
Model	NCS 6000 Series
Category	Network Router
Language	English