.
.
If-Policy-In
The if-policy-in attach point allows you to filter routes received on a particular EIGRP interface. The following
example shows an inbound policy for GigabitEthernet interface 0/2/0/3:
router eigrp 100
address-family ipv4
interface GigabitEthernet0/2/0/3
route-policy if-filter-policy-in in
.
.
.
If-Policy-Out
The if-policy-out attach point allows you to filter routes sent out on a particular EIGRP interface. The following
example shows an outbound policy for GigabitEthernet interface 0/2/0/3:
router eigrp 100
address-family ipv4
interface GigabitEthernet0/2/0/3
route-policy if-filter-policy-out out
.
.
.
Redistribute
The redistribute attach point in EIGRP allows you to filter redistributed routes from other routing protocols
and modify some routing parameters before installing the route in the EIGRP database. The following example
shows a policy filter redistribution of RIP routes into EIGRP.
router-policy redistribute-rip
if destination in (100.1.1.0/24) then
set eigrp-metric 5000000 4000 150 30 2000
else
set tag 200
endif
end-policy
router eigrp 100
address-family ipv4
redistribute rip route-policy redistribute-rip
.
.
.
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
439
Implementing Routing Policy
If-Policy-In
To Next Page
Loading...
Need help?
General
