Managing the System
Network Services
Cisco Small Business NSS 322, NSS 324, and NSS 326 Smart Storage Administration Guide 131
3
STEP 6
You can enable or disable anonymous login to the FTP site by clicking
Yes
(enabled) or
No
(disabled) in the
Ena ble d Anonym ou s
field. The default setting is
No
.
STEP 7
Enter the FTP C onne ction par am eters:
•
Maximum number of all FTP connections
—Maximum number of clients
that can be connected at the same time. The upper limit is 256.
•
Maxim u m Numb er of Conne cti ons for a Single Ac c ou nt
—Maximum
number of connections for a single account. The upper limit is 256.
•
FTP transfer limitation
—You can set the maximu m uploa d and down load
rates. Clic k
Enab le F T P trans fer lim it ation
to set these parameters then
enter upload and dow nload maxim um v alue s .
STEP 8
Enter Advanc e d F T P par am eters:
•
Passive FTP Port Range
—You can us e the default p ort range (55 536-
5655 9) or define a port range high er than 10 24 .
•
Respond with external IP address for passive FTP connection request
—
You can enable this function when a remot e computer is not able t o connect
to the FTP server using a WAN connection where the FTP server is be hind a
router/firewall. When this function is enabled the FTP server returns the
manua lly spe cified IP add res s or au tomatically detects the external IP
address so that the remote computer can connect to the FTP server
successfully.
STEP 9
Click
Apply
. Your FTP service settings are updated to the NAS.
Telnet/SSH
From the
Net work Ser vices > Telnet/SSH
window, you can allow access to the
NAS using a Telnet or SSH connection.
NOTE
Only the “admin” account can login remotely. User with administrator privileges is
not allowed to login remotely.
To Next Page
Loading...
