Cisco ONS 15454 - Page 6

NTP-G12 Install and Close the FMEC Cover (ETSI Only) 117
NTP-G13 Install the Rear Cover (ANSI Only) 118
Typical DWDM Rack Layouts 120
NTP-G14 Install DWDM Equipment 123
DLP-G27 Install the DCU Shelf 123
DLP-G28 Install the Fiber Patch-Panel Tray 124
DLP-G29 Install the Fiber-Storage Tray 125
DLP-G371 Install the Ethernet Adapter Panel 126
DLP-G352 Install the Y-Cable Module Tray 126
DLP-G30 Install the FlexLayer Shelf 127
DLP-G31 Install the FlexLayer Modules 128
DLP-G32 Install the Y-Cable Protection Modules in the FlexLayer Shelf 129
DLP-G377 Install the Y-Cable Protection Modules in the Y-Cable Module Tray 130
NTP-G15 Install the Common Control Cards 131
DLP-G33 Install the TCC2, TCC2P, or TCC3 Card 132
DLP-G34 Install the AIC-I Card 135
DLP-G309 Install the MS-ISC-100T Card 136
Multishelf Management 137
Multishelf LAN Topologies 137
ONS 15454 Multishelf Node and Subtending Shelves 138
ONS 15454 Multishelf Node and Subtending Shelves—Upgrade 138
NTP-G301 Connect the ONS 15454 Multishelf Node and Subtending Shelves to an MS-ISC-100T
Card 138
NTP-G304 Configure the MS-ISC-100T Card for a ONS 15454 Multishelf Node for Non-Default Public
and Private VLAN IDs 141
NTP-G307 Perform the ONS 15454 Shelf Installation Acceptance Test 143
DLP-G35 Inspect the Shelf Installation and Connections 145
DLP-G36 Measure Voltage 146
NTP-G295 Connect the ONS 15454 Multishelf Node and Subtending Shelves to a Catalyst 2950 or
Catalyst 3560 146
NTP-G296 Upgrade the ONS 15454 Multishelf with MS-ISC Card Configuration Using the Catalyst
3560 148
NTP-G297 Upgrade the ONS 15454 Multishelf with Catalyst 2950 Configuration Using the Catalyst
3560 150
Cisco ONS 15454 Hardware Installation Guide
vi
Contents