Cloos QINEO NexT - Storage Management

129
• Quick save
1. Press the left rotary knob while the start screen is displayed. To
open the start screen, press the menu button.
2. Turn the rotary knob to select a storage space.
3. Press the left rotary knob for approx. 2 seconds until the selected
field turns yellow and "STO" appears.
Parameters already saved in the field are replaced by new values.
• Quick load
1. Press the left rotary knob while the start screen is displayed. To
open the start screen, press the menu button.
2. Turn the rotary knob to select a storage space.
3. Press the left rotary knob to load the saved parameters.
• Quick delete
1. Press the left rotary knob while the start screen is displayed. To
open the start screen, press the menu button.
2. Turn the rotary knob to select a storage space.
3. Press the left rotary knob for approx. 4 seconds until the selected
field turns yellow and "DEL" appears.
• Deactivate active quick memory
1. Press the left rotary knob while the start screen is displayed. To
open the start screen, press the menu button.
2. Select and confirm the exit symbol by means of the left rotary
knob.
The loaded welding parameters of the quick memory are deactivated.
4.3.2 Storage management
The storage management is available as an optional function. To activate
the option, please read Chapter "5.12 Options" on page 146.
Press the job button for approx. 3 seconds.
The following options are available in the storage management:
• Save job
• Save job with name
• Delete job
• Job off (if job is loaded and active)
Menu button
ATTENTION!
Menu button
Menu button
Menu button
Job button