147
5.13 Activation code
By means of activation codes, the software and machine configurations
can be enabled.
If all information is correct, the newly activated option is listed in the "Acti-
vated options" overview.
If an error occurred during the transmission or input of the activation
code, the error message 317 "Wrong activation code!" appears. Check your
entries and repeat the process.
5.14 Time
In the "Config - Clock" menu you can enter the exact time and date by
means of the rotary knob.
5.15 Off / Re-start
In this menu you can switch off or restart the welding power source via the
operating module.
1. Use the rotary knob to select a corresponding function for switching
off or restarting.
2. Press and hold the rotary knob. The selected function is executed after
5 seconds at the latest.
5.16 Torch remote control
Changes to the configuration will only be transferred to the torch remote
control upon having restarted the welding power source.
To call up the menu, read Section "Configuration menu" on page 132.
For more information about the configuration, refer to the documentation
for the respective welding torch.
INFO!
To Next Page
Loading...
