Cloos QINEO NexT - Attach the Protective Hose; Attach the Corrugated Tube; Recommended Laying of Connector Cables; Final Tasks on QWD-M5

174
QINEO Wire Drive M5
4.2.2 Attach the protective hose
4.2.3 Attach the corrugated tube
4.2.4 Recommended laying of connector cables
Do not bend the water hoses.
4.2.5 Final tasks on QWD-M5
Repeat steps 7 to 1. Please observe the reverse direction of the arrow.
Note to step 3: Use the clamp screw to adjust the braking force of the wire
coil holder so that it does not run when the motor brakes and no wire
windings fall off the coil, possibly resulting in kinking or short circuits. If
the brake does no longer work, the brake disk must be replaced!
Note to step 1: The wire coil must be secured on the wire coil holder with
the locking button to prevent it falling off.
1
2
Hex key 5 AF
3
Star screwdriver 25 AF
ATTENTION!
1 2 3
INFO!
INFO!
1
2
Hex key 5 AF
3
Star screwdriver 25 AF