72
MAIN (2) - Config (Configuration)
Exit the "Config"- "Access management" menu by pressing rotary knob 3 or
the "Esc" key!
Forgotten your password?
After 5 unsuccessful attempts to enter the password, an 8-digit code num-
ber appears below the "Access code" line.
With the aid of the code number it is possible to decode the password by
calling the CLOOS Service Hotline. You can now enter the code number
again.
9.4.2 Config - User management and PAK (option)
The access rights to certain functions, adjustments and welding
parameters are enabled or blocked and saved in a user profile via the user
management.
The user management allows to transfer these user profiles to a PAK
(Personal Access Key) each. For this, the welding power source or the
operating module must dispose of a PAK port.
The PAK is connected to the PAK port of the welding power source and the
user profile is loaded. The user is automatically logged on to the welding
power source as soon as the information saved in the PAK match with the
information saved in the welding power source. The respective user profile
is then activated in the welding power source.
If a user logs in who is new for the welding power source, the access is
either denied or his user profile is transferred into the user management
and stored, depending on the setting. The respective user profile is then
activated in the welding power source.
Operating level after switching on
This menu item enables you to determine the preset operating level
after switching on the welding power source. You can select between
"Automatic", "Programmer" and "Configurator".
Figure 42. "Config" - "Access management" - "Options" menu
INFO!
To Next Page
Loading...
