Cloos QINEO NexT - Diagnostics - Control - Tandem; Diagnostics - Process Control

87
10.3.5 Diagnostics - Control - Tandem
This menu displays the Tandem configuration and the Tandem state of the
welding power source.
10.4 Diagnostics - Process control
This menu displays the characteristic curves and data sets recognised by
the process control that are currently in the welding power source.
Software version corresponds to DSP software, see "Diagnostics" --> "Soft-
ware version" "Modules:" "QN DSP".
D I A G N O S E - Tandem
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Garätekonfiguration
Tandem – Funktion Aus
Tandem – Status
- Tandem Aus
Diagnose Tandem
Figure 63. "Diagnostics" - "Control"- "Tandem" menu
Diagnose - Prozessregelung
Impuls-
synchr.
Datensatz
Info
Aktuelle
Kennlinie
Software-Version 00.10.00
Kennlinien 1/1024
Fehlerhafte Kennlinien 1/1
Datensätze 1/64
Unformatierte Datensätze 0
Diagnose Prozessregelung
Figure 64. "Diagnostics" - "Process control" menu