Cloos QINEO NexT - Diagnostics - Cooling Module - LED

98
MAIN (2) - Diagnostics
10.7.1 Diagnostics - cooling module - LED
In this menu you test the functionality of the LED of the welding power
source. To test the functionality, set the mode to "Diagnostics" with the
middle rotary knob.
The parameters can now be changed. The LED adapts to the changed
values.
Diagnose - Led
Diagnose Led
Mode
Frequenz 0.1 Hz
Tastverhältnis 100 %
Rot 10 %
Grün 0 %
Blau 0 %
Diagnose
Figure 86. "Diagnostics" - "Control"- "LED" Diagnostics mode active menu
Diagnose - Led
Diagnose Led
Mode
Frequenz 0.1 Hz
Tastverhältnis 100 %
Rot 10 %
Grün 0 %
Blau 0 %
Diagnose
0.1 Hz
Figure 87. "Diagnostics" - "Control"- "LED" Edit LED status menu