Cloos QINEO NexT - MAIN - Programming - Tandem; MAIN - Programming - Pulse Synchronisation; MAIN - Programming - Expert Mode

52
MAIN - Programming
Use the "Setting range Off" function to set the selected range to "Off", see
Figure 19.
You will return to the "MAIN" menu by pressing the "Esc" key or by pressing
again the rotary knob 3.
6.5 MAIN - Programming - Tandem
For further information and prerequisites for configuring the Tandem
operating mode, see section "3. Basic configuration Operating mode "Tan-
dem"" on page 217.
If the "Expert Mode" function is active, the function is under MAIN - Pro-
gramming(2).
6.6 MAIN - Programming - Pulse synchronisation
For further information and prerequisites for configuring the Pulse syn-
chronisation function, see section "4. Pulse synchronisation" on page 226.
If the "Expert Mode" function is active, the function is under MAIN - Pro-
gramming(2).
6.7 MAIN - Programming - Expert Mode
This section does not apply to welding power sources type:
• QINEO NexT Master
The "Expert Mode" is an alternative operating possibility to the synergy
mode. The "Expert Mode" requires a fundamental knowledge of the pulsed
arc welding process and is only recommended for users having a good
experience in welding.
When the "Expert Mode is "active, the background of the text field is high-
lighted in yellow. In synergy mode the text field is blue.
INFO!
INFO!
INFO!
Start-
parameter
P R O G R A M M I E R E N
R
ücksetzen
auf
Synergie
werte
S-Puls 4
-Takt
V
0
A
1.2 mm Fe
82% Argon 18% CO
2
0.0
Gasvorstr
ö
men
0.3 sek
Einschleichen 2.5 m/min
Freibrand 40 %
Expert
Mode
Ende
-
parameter
Duo
-
Puls
Haupt
Gasnachströmen 1.0 sek
Z
ündmodus
CleanStart
Start-
parameter
P R O G R A M M I E R E N
R
ücksetzen
auf
Synergie
werte
S-Puls 4
-Takt
V
0
A
1.2 mm Fe
82% Argon 18% CO
2
0.0
Gasvorstr
ö
men
0.3 sek
Einschleichen 2.5 m/min
Freibrand 40 %
Expert
Mode
Ende
-
parameter
Duo
-
Puls
Haupt
Gasnachströmen 1.0 sek
Z
ündmodus
CleanStart
Figure 20. "Programming" "Expert Mode" function active menu