Cloos QINEO NexT - Page 6

5.2 CleanStart...............................................................................................................44
5.3 Blow through ........................................................................................................44
5.4 Threading (only in connection with MoTion Equipment) ................ 44
5.5 Wire forward .........................................................................................................44
5.6 Wire backward .....................................................................................................44
5.7 Gas manually ........................................................................................................44
5.8 Start manually .....................................................................................................45
5.9 Off / Re-start ..........................................................................................................45
6. MAIN - Programming ...................................................................................45
6.1 Parameters in the operating modes 2-cycle and 4-cycle ...................46
6.2 Parameters in the operating mode Super-4-cycle ...............................47
6.3 Parameters in operating mode Spot Welding / Interval ...................48
6.4 MAIN - Programming - Setting ranges ...................................................... 49
6.4.1 Input of setting ranges ..................................................................................... 49
6.4.2 Prerequisite to use the setting ranges ......................................................50
6.4.3 Deactivating the setting ranges ................................................................... 51
6.5 MAIN - Programming - Tandem....................................................................52
6.6 MAIN - Programming - Pulse synchronisation ......................................52
6.7 MAIN - Programming - Expert Mode .........................................................52
6.7.1 Expert Mode - Reset to synergy values ......................................................53
6.7.2 Main parameters in the "Expert Mode" ....................................................53
6.7.3 Secondary parameters in the "Expert Mode" .........................................54
6.7.4 "DuoPulse parameters" in the "Expert Mode" ........................................ 54
6.8 Main - Programming - Active QWD ............................................................55
6.9 Main - Programming - Welding circuit (from x.02) ............................. 55
7. MAIN - Measured values ..............................................................................55
7.1 Operating data .....................................................................................................56
7.1.1 Data set switching 1/2 .....................................................................................57
7.1.2 Seam counter Setup ..........................................................................................57
7.1.3 Consumption costs ............................................................................................58
8. MAIN - Display ...............................................................................................58
9. MAIN (2) - Config (Configuration) ..............................................................60
9.1 Config - General ...................................................................................................60
9.1.1 Display brightness ..............................................................................................61
9.1.2 MHW x10 Master ................................................................................................61
9.1.3 Control coolant pump and fan .....................................................................61
9.1.4 Config - General - Basic settings ...................................................................62
9.1.5 Config - General - Basic settings (2) ............................................................63
9.1.6 Config - General - Sense technology ........................................................... 64
9.1.7 Config - General - QWD ....................................................................................64
9.1.8 Config - General - SD module ........................................................................66
9.1.9 Config - General - Options ...............................................................................66
9.2 Config - Water monitoring ..............................................................................68
9.3 Config - Compensation .....................................................................................69
9.4 Access rights .......................................................................................................... 70
9.4.1 Config - Access management ........................................................................ 70
9.4.2 Config - User management and PAK (option) ........................................72
9.5 Config - Ethernet .................................................................................................77
9.6 Config - Clock ........................................................................................................78
9.7 Config - Process monitoring ........................................................................... 78
9.8 Config - General (2) ............................................................................................79
9.9 Config - General (3) ............................................................................................80
10. MAIN (2) - Diagnostics ..................................................................................80
10.1 Diagnostics - Software versions ...................................................................81
10.2 Diagnostics - System logbook ........................................................................ 81