Cloos QINEO NexT - Page 8

3. Description of the additional functions ................................................ 117
3.1 DuoPulse ..............................................................................................................117
3.2 CleanStart............................................................................................................117
3.3 QWD .......................................................................................................................117
3.4 Functions - System logbook ........................................................................118
3.5 Functions - Diagnostics .................................................................................118
3.5.1 Diagnostics - Software versions ................................................................118
3.5.2 Diagnostics - Power unit ............................................................................... 118
3.5.3 Diagnostics - Cooling module .................................................................... 119
3.5.4 Diagnostics - Process control ...................................................................... 119
3.6 Functions - Information ................................................................................119
3.7 Functions - Loading Saving .......................................................................... 120
4. Operation ..................................................................................................... 121
4.1 Operating concept for the operating modes ......................................121
4.1.1 Operating mode 2-cycle ................................................................................121
4.1.2 Operating mode 4-cycle ................................................................................122
4.1.3 Operating mode Super-4-cycle .................................................................. 123
4.1.4 Operating mode Spot welding/Interval ................................................124
4.2 Configuration of characteristic curve ..................................................... 124
4.2.1 Adjusting secondary parameters .............................................................124
4.2.2 Restore the original state of the secondary parameters ................125
4.2.3 Parameters of operating modes "2-cycle" and "4-cycle" ................. 125
4.2.4 Additional parameters of operating mode "Super-4-cycle" ..........126
4.2.5 Additional parameters of operating mode "Spot Welding/Interval"
..................................................................................................................................126
4.2.6 Parameter setting ranges (optional) ....................................................... 126
4.3 Save and load job .............................................................................................128
4.3.1 Quick memory access ..................................................................................... 128
4.3.2 Storage management .................................................................................... 129
5. Configuration menu .................................................................................. 132
5.1 Language .............................................................................................................132
5.2 Basic settings ..................................................................................................... 133
5.2.1 Basic screen ........................................................................................................133
5.2.2 2-cycle start and end crater program ..................................................... 133
5.2.3 Fine adjustment ............................................................................................... 133
5.2.4 Control voltage mode ..................................................................................... 134
5.2.5 External selection of process ......................................................................134
5.2.6 Reset to factory setting..................................................................................134
5.2.7 Polarity "+/-" connection ............................................................................... 134
5.2.8 Application range of power source ..........................................................134
5.3 Config - General ................................................................................................ 135
5.3.1 Automatic Hold display .................................................................................135
5.3.2 MHW X10 Master .............................................................................................135
5.3.3 Cooling water pump .......................................................................................135
5.3.4 Job continuation...............................................................................................135
5.4 Config - General (2) .........................................................................................136
5.4.1 Wire speed in ..................................................................................................... 136
5.4.2 V-display shows ................................................................................................136
5.4.3 Gas flow - min/max ........................................................................................ 136
5.4.4 TIG - pot setting range - min/max ...........................................................136
5.5 Compensation of the external welding circuit .................................. 136
5.6 Process monitoring ......................................................................................... 138
5.7 Cooling water monitoring ........................................................................... 138
5.8 Sense technology .............................................................................................139
5.9 QWD .......................................................................................................................140
5.9.1 QWD PushPull ...................................................................................................140
5.9.2 Wire end control ...............................................................................................140
5.10 Locking/unlocking functions ......................................................................140
5.10.1 Access management ......................................................................................141