Table of contents
2 99-145912-A
3.3 Installation of the ADU ............................................................................................3-17
3.3.1 To install the ADU ............................................................................................................3-18
3.3.2 To open and remove the service hatch ................................................................3-21
3.3.3 To ground the ADU .........................................................................................................3-22
3.3.4 Alternative ADU cable ...................................................................................................3-23
3.4 Installation of the ACU ............................................................................................3-24
3.4.1 To install the ACU ............................................................................................................ 3-24
3.4.2 To ground the ACU .........................................................................................................3-24
3.5 Installation of the GMU ...........................................................................................3-25
3.5.1 To install the GMU ...........................................................................................................3-25
3.5.2 To ground the GMU ........................................................................................................3-25
3.5.3 Provisioning key and terminal type .........................................................................3-25
3.6 To connect the ADU, ACU and GMU .............................................................3-26
Chapter 4 Interfaces
4.1 Interfaces of the ACU ..................................................................................................4-1
4.1.1 LEDs, display, keypad and connectors ......................................................................4-1
4.1.2 DC Input connector ...........................................................................................................4-2
4.1.3 ADU connector ....................................................................................................................4-2
4.1.4 Rx In and Tx Out connectors .......................................................................................4-3
4.1.5 NMEA 0183 connector ....................................................................................................4-3
4.1.6 RS-232 and RS-422 connectors ...................................................................................4-4
4.1.7 LAN1 – 4 connectors .........................................................................................................4-5
4.2 Interfaces of the GMU .................................................................................................4-6
4.2.1 Connector panel ..................................................................................................................4-6
4.2.2 Rx In and Tx Out connectors .......................................................................................4-6
4.2.3 RS-232 and RS-422 connectors ...................................................................................4-7
4.2.4 LAN connectors (8 + 2) ....................................................................................................4-8
4.2.5 I/O connector for Tx Mute and Rx Lock ..................................................................4-8
4.2.6 Rx In and Tx Out connectors ........................................................................................4-8
Chapter 5 Power and startup
5.1 Power source .......................................................................................................................5-1
5.2 Power cables ........................................................................................................................5-1
5.2.1 Power cable selection (ACU) .........................................................................................5-1
5.2.2 Power cable of the GMU .................................................................................................5-3
5.3 Power up .................................................................................................................................5-3
5.3.1 To connect the power cable to the ACU and GMU ...........................................5-3
5.3.2 Power-up procedure ..........................................................................................................5-4
5.3.3 Initialisation steps in daily use ......................................................................................5-4
5.3.4 SAILOR 100 GX operational ...........................................................................................5-5