Codan HF SSB - Emergency selcall receive setup

Setup procedures—Part 2
HF SSB transceiver reference manual 6-11
Emergency selcall receive setup
Setup code 24422
This procedure is used to set up the transceiver for receiving
emergency selcalls.
You can select:
•
DISABLED
if you do not want to receive emergency
selcalls
•
RECEIVE-ALL
if you want to receive all emergency
selcalls on channels scanned by the transceiver
•
SELECTIVE
if you only want to receive emergency
selcalls to your address and up to two additional
addresses.
To set up how you receive emergency selcalls:
Action Notes
1.
Repeatedly press
Mode
until you see the
display for Setup mode.
The display shows:
EXIT
SETUP MENU
1–Scan
2–Call
ENTER
3–Config
4–More
1/2
Setup procedures—Part 2
HF SSB transceiver reference manual 6-11
Emergency selcall receive setup
Setup code 24422
This procedure is used to set up the transceiver for receiving
emergency selcalls.
You can select:
•
DISABLED
if you do not want to receive emergency
selcalls
•
RECEIVE-ALL
if you want to receive all emergency
selcalls on channels scanned by the transceiver
•
SELECTIVE
if you only want to receive emergency
selcalls to your address and up to two additional
addresses.
To set up how you receive emergency selcalls:
Action Notes
1.
Repeatedly press
Mode
until you see the
display for Setup mode.
The display shows:
EXIT
SETUP MENU
1–Scan
2–Call
ENTER
3–Config
4–More
1/2