Codan HF SSB User Manual

Setup procedures—Part 3
HF SSB transceiver reference manual 7-29
RS-232 connection baud rate
Setup code 3412 (standard procedure)
This procedure is used to set the speed of information
transfer for equipment connected to either the
RS-232
socket or
GP
connector on the transceiver rear panel.
You can select the following baud rates:
•
300
•
600
•
1200
•
2400
•
4800
•
9600.
For a GPS receiver, the baud rate is usually 4800. For a
computer or an ALE controller, the baud rate is usually
9600.
To set the baud rate for the
RS-232
socket and
GP
connector:
Action Notes
1.
Repeatedly press
Mode
until you see the
display for Setup mode.
The display shows:
EXIT
SETUP MENU
1–Scan
2–Call
ENTER
3–Config
4–More
1/2
Setup procedures—Part 3
HF SSB transceiver reference manual 7-29
RS-232 connection baud rate
Setup code 3412 (standard procedure)
This procedure is used to set the speed of information
transfer for equipment connected to either the
RS-232
socket or
GP
connector on the transceiver rear panel.
You can select the following baud rates:
•
300
•
600
•
1200
•
2400
•
4800
•
9600.
For a GPS receiver, the baud rate is usually 4800. For a
computer or an ALE controller, the baud rate is usually
9600.
To set the baud rate for the
RS-232
socket and
GP
connector:
Action Notes
1.
Repeatedly press
Mode
until you see the
display for Setup mode.
The display shows:
EXIT
SETUP MENU
1–Scan
2–Call
ENTER
3–Config
4–More
1/2

Codan HF SSB Specifications

General

Brand	Codan
Model	HF SSB
Category	Transceiver
Language	English