Codan HF SSB - Emergency selcall transmit setup

Setup procedures—Part 2
HF SSB transceiver reference manual 6-15
Emergency selcall transmit setup
Setup code 24421
This procedure is used to set up the transceiver for sending
emergency selcalls.
The transceiver sends an emergency call when you press the
Emgcy Call
button on the control panel if you have used
this procedure to set up the address to call.
You can set up:
• the address to call
• up to four emergency channels.
To set up the address to call and the channel to use when
sending an emergency selcall:
Action Notes
1.
Repeatedly press
Mode
until you see the
display for Setup mode.
The display shows:
EXIT
SETUP MENU
1–Scan
2–Call
ENTER
3–Config
4–More
1/2
2.
Enter 24421
numeral
button
Example of the display:
CLEAR
Emergency Selcall:
ENTER
Call address: – – – – – –
Enter Emergency Adr
Setup procedures—Part 2
HF SSB transceiver reference manual 6-15
Emergency selcall transmit setup
Setup code 24421
This procedure is used to set up the transceiver for sending
emergency selcalls.
The transceiver sends an emergency call when you press the
Emgcy Call
button on the control panel if you have used
this procedure to set up the address to call.
You can set up:
• the address to call
• up to four emergency channels.
To set up the address to call and the channel to use when
sending an emergency selcall:
Action Notes
1.
Repeatedly press
Mode
until you see the
display for Setup mode.
The display shows:
EXIT
SETUP MENU
1–Scan
2–Call
ENTER
3–Config
4–More
1/2
2.
Enter 24421
numeral
button
Example of the display:
CLEAR
Emergency Selcall:
ENTER
Call address: – – – – – –
Enter Emergency Adr