Codan HF SSB - Power up message on;off

Setup procedures—Part 3
7-10 HF SSB transceiver reference manual
Power up message on/off
Setup code 34411 (standard procedure)
This procedure is used to set up a message that is displayed
for several seconds when the transceiver is first switched on.
To set or cancel a power up message:
Action Notes
1.
Repeatedly press
Mode
until you see the
display for Setup mode.
The display shows:
EXIT
SETUP MENU
1–Scan
2–Call
ENTER
3–Config
4–More
1/2
2.
Enter 34411
numeral
button
Example of the display:
EXIT PROG
ENABLED
Power Up Message
or
EXIT
Power Up Message
ENTER
DISABLED
Setup procedures—Part 3
7-10 HF SSB transceiver reference manual
Power up message on/off
Setup code 34411 (standard procedure)
This procedure is used to set up a message that is displayed
for several seconds when the transceiver is first switched on.
To set or cancel a power up message:
Action Notes
1.
Repeatedly press
Mode
until you see the
display for Setup mode.
The display shows:
EXIT
SETUP MENU
1–Scan
2–Call
ENTER
3–Config
4–More
1/2
2.
Enter 34411
numeral
button
Example of the display:
EXIT PROG
ENABLED
Power Up Message
or
EXIT
Power Up Message
ENTER
DISABLED