Codan HF SSB - RS-232 connected equipment

Setup procedures—Part 3
7-26 HF SSB transceiver reference manual
RS-232 connected equipment
Setup code 3411 (standard procedure)
This procedure is used to identify the equipment connected
to either the
RS-232
socket or
GP
connector on the
transceiver rear panel.
Select:
•
NONE
(if nothing is connected)
•
COMPUTER
(if a computer is connected)
•
GPS NMEA-0183
(if a GPS receiver is connected)
•
9300 ALE
(if an ALE controller is connected).
To change the setting for the equipment connected to the
RS-232
socket or
GP
connector:
Action Notes
1.
Repeatedly press
Mode
until you see the
display for Setup mode.
The display shows:
EXIT
SETUP MENU
1–Scan
2–Call
ENTER
3–Config
4–More
1/2
Setup procedures—Part 3
7-26 HF SSB transceiver reference manual
RS-232 connected equipment
Setup code 3411 (standard procedure)
This procedure is used to identify the equipment connected
to either the
RS-232
socket or
GP
connector on the
transceiver rear panel.
Select:
•
NONE
(if nothing is connected)
•
COMPUTER
(if a computer is connected)
•
GPS NMEA-0183
(if a GPS receiver is connected)
•
9300 ALE
(if an ALE controller is connected).
To change the setting for the equipment connected to the
RS-232
socket or
GP
connector:
Action Notes
1.
Repeatedly press
Mode
until you see the
display for Setup mode.
The display shows:
EXIT
SETUP MENU
1–Scan
2–Call
ENTER
3–Config
4–More
1/2