To Next Page

To Previous Page

Using Setup mode procedures

4-2 HF SSB transceiver reference manual

Using Setup mode

You enter Setup mode by pressing the

Mode

button on the

control panel four times starting from the Channel mode

setting.

Setup mode only displays the names of Setup mode

procedures fitted or enabled for your transceiver. The names

of unavailable procedures are blanked out.

The easiest way to use Setup mode is to find the procedure

you want from the following list and turn to the description

of the procedure for further details and step by step guidance.

Procedures are listed alphabetically in Chapters 5–8.

You start each transceiver procedure by entering a setup

code.

If you make a mistake in setting a value and want to avoid

saving your changes, press the

button on the control

panel or

PTT

on the microphone to return to an earlier step

in the procedure. Repeated pressing of either button

progresses you back to Channel mode.

If you do not touch any button or knob for 60 seconds while

in Setup mode, the transceiver automatically reverts to

Channel mode. If this happens while you are in the middle

of a procedure, start the procedure again.

The descriptions for the procedures show examples of

channel and frequency numbers. You must enter your own

values.

