Channel and scan table setup
HF SSB transceiver reference manual 3-29
Telephone directory creation
This procedure is used to set up the telephone directory for
sending telcalls.
The telephone directory operates like a telephone book. It
can hold ten telephone entries (numbered 0–9). Each entry
consists of a telephone number and a comment.
You can only access the telephone directory from channels
that allow selcalling (channels attached to a selcall group).
To check the selcall group setting for a channel, refer to the
HF SSB transceiver user guide, Chapter 3, Using View
Channel Options mode.
To add or clear entries from the telephone directory:
Action Notes
1.
In Channel mode,
select a channel that is
set up for selcalling.
You can only access the
telephone directory from a
selcall channel.
2.
Press
Call
Example of the display:
USB
HI
CALL
Rx.
149
2040
TYPE
Selcall: 894477
3.
Press
Enter
R'call
Example of the display:
USB
HI
CALL
Rx.
149
2040
ENDCALL
Tel:
– – – – – – –
029712233
Channel and scan table setup
HF SSB transceiver reference manual 3-29
Telephone directory creation
This procedure is used to set up the telephone directory for
sending telcalls.
The telephone directory operates like a telephone book. It
can hold ten telephone entries (numbered 0–9). Each entry
consists of a telephone number and a comment.
You can only access the telephone directory from channels
that allow selcalling (channels attached to a selcall group).
To check the selcall group setting for a channel, refer to the
HF SSB transceiver user guide, Chapter 3, Using View
Channel Options mode.
To add or clear entries from the telephone directory:
Action Notes
1.
In Channel mode,
select a channel that is
set up for selcalling.
You can only access the
telephone directory from a
selcall channel.
2.
Press
Call
Example of the display:
USB
HI
CALL
Rx.
149
2040
TYPE
Selcall: 894477
3.
Press
Enter
R'call
Example of the display:
USB
HI
CALL
Rx.
149
2040
ENDCALL
Tel:
– – – – – – –
029712233