Codan HF SSB User Manual

Channel and scan table setup
3-22 HF SSB transceiver reference manual
Scan table creation
This procedure is used to set up any of the three scan tables.
You can only make changes to scan tables if scan table
editing is switched on (see Chapter 8, Scan table editing
on/off).
Each scan table can hold up to ten receive frequency
channels. You can add a channel to the scan table more than
once if you want the channel to be scanned several times in
each scan cycle.
You can select one of five scan types as displayed:
Selcall
Selcall scanning is the normal setting if you
expect to receive selcalls. Mute is on so that no
voice transmissions are heard. (Use of selcall
mute needs to be on. See Chapter 8, Selcall
mute availability on/off.)
Each channel is scanned for 0.6 seconds.
Scanning only stops for selcalls.
Cont
Use Continuous scanning if you want to listen to
voice traffic as the channels are scanned.
Each channel is scanned for 0.6 seconds.
Scanning only stops for selcalls. Mute is off.
Pause
Use Pause scanning if you expect voice calls and
want scanning to pause for five seconds when
voice is detected on the channel.
Each channel is scanned for one second.
Scanning also stops for selcalls.
Channel and scan table setup
3-22 HF SSB transceiver reference manual
Scan table creation
This procedure is used to set up any of the three scan tables.
You can only make changes to scan tables if scan table
editing is switched on (see Chapter 8, Scan table editing
on/off).
Each scan table can hold up to ten receive frequency
channels. You can add a channel to the scan table more than
once if you want the channel to be scanned several times in
each scan cycle.
You can select one of five scan types as displayed:
Selcall
Selcall scanning is the normal setting if you
expect to receive selcalls. Mute is on so that no
voice transmissions are heard. (Use of selcall
mute needs to be on. See Chapter 8, Selcall
mute availability on/off.)
Each channel is scanned for 0.6 seconds.
Scanning only stops for selcalls.
Cont
Use Continuous scanning if you want to listen to
voice traffic as the channels are scanned.
Each channel is scanned for 0.6 seconds.
Scanning only stops for selcalls. Mute is off.
Pause
Use Pause scanning if you expect voice calls and
want scanning to pause for five seconds when
voice is detected on the channel.
Each channel is scanned for one second.
Scanning also stops for selcalls.

Codan HF SSB Specifications

General

Brand	Codan
Model	HF SSB
Category	Transceiver
Language	English