Codan HF SSB - Transceiver reset to factory settings

Link Setup mode
HF SSB transceiver reference manual 9-13
Transceiver reset to factory settings
This procedure is used to reset the transceiver to factory
settings.
You can:
• delete all unprotected channels
• reset user settings to the factory default values
• reset user settings to the factory default values and delete
all channels (full transceiver reset to factory condition).
Think carefully before deleting all channels since this
includes all your protected channels set up by Codan! If you
delete all channels and your transceiver is not fitted with the
option TXE, you will be unable to use the transceiver until
your transmit channels are entered again by Codan.
User settings include all settings in the transceiver except
for:
• channel information
• PIN
• transceiver options installed by Codan or enabled by
password
• display brightness and contrast settings.
Link Setup mode
HF SSB transceiver reference manual 9-13
Transceiver reset to factory settings
This procedure is used to reset the transceiver to factory
settings.
You can:
• delete all unprotected channels
• reset user settings to the factory default values
• reset user settings to the factory default values and delete
all channels (full transceiver reset to factory condition).
Think carefully before deleting all channels since this
includes all your protected channels set up by Codan! If you
delete all channels and your transceiver is not fitted with the
option TXE, you will be unable to use the transceiver until
your transmit channels are entered again by Codan.
User settings include all settings in the transceiver except
for:
• channel information
• PIN
• transceiver options installed by Codan or enabled by
password
• display brightness and contrast settings.