Codan HF SSB - 7 Setup procedures-part 3

HF SSB transceiver reference manual 7-1
7 Setup procedures—part 3
This chapter contains the following Setup mode procedures:
• Page call canned message setup (7-2)
• Password entry to enable transceiver options* (7-5)
• Power up message on/off* (7-10)
• Power up mute setting* (7-13)
• Power up address display on/off (7-16)
• PTT release beep on/off* (7-18)
• PTT transmit cutout* (7-20)
• Recall channels by frequency on/off* (7-22)
• RF gain on/off* (7-24)
• RS-232 connected equipment* (7-26)
• RS-232 connection baud rate* (7-29).
* indicates a standard procedure available in all HF SSB
series transceivers (see Chapter 4, Using Setup mode
procedures).
HF SSB transceiver reference manual 7-1
7 Setup procedures—part 3
This chapter contains the following Setup mode procedures:
• Page call canned message setup (7-2)
• Password entry to enable transceiver options* (7-5)
• Power up message on/off* (7-10)
• Power up mute setting* (7-13)
• Power up address display on/off (7-16)
• PTT release beep on/off* (7-18)
• PTT transmit cutout* (7-20)
• Recall channels by frequency on/off* (7-22)
• RF gain on/off* (7-24)
• RS-232 connected equipment* (7-26)
• RS-232 connection baud rate* (7-29).
* indicates a standard procedure available in all HF SSB
series transceivers (see Chapter 4, Using Setup mode
procedures).