Codan HF SSB User Manual

Setup procedures—Part 1
HF SSB transceiver reference manual 5-23
Clock setting
Setup code 411 (standard procedure)
This procedure is used to set the time and date of the
transceiver clock.
The time is always shown in 24 hour format. The clock is
used for timing incoming selective calls recorded in call
memory.
To change the clock setting, you must complete the
procedure. If you exit the procedure before the end, all
changes are lost.
The clock stops during the procedure. When you complete
the procedure, it restarts using the new settings.
To set the clock:
Action Notes
1.
Repeatedly press
Mode
until you see the
display for Setup mode.
The display shows:
EXIT
SETUP MENU
1–Scan
2–Call
ENTER
3–Config
4–More
1/2
2.
Enter 411
numeral
button
The clock stops running.
Example of the display:
EXIT
TIME SETUP
16:01 D/M/Y 03/05/97
ENTER
Enter hours
Setup procedures—Part 1
HF SSB transceiver reference manual 5-23
Clock setting
Setup code 411 (standard procedure)
This procedure is used to set the time and date of the
transceiver clock.
The time is always shown in 24 hour format. The clock is
used for timing incoming selective calls recorded in call
memory.
To change the clock setting, you must complete the
procedure. If you exit the procedure before the end, all
changes are lost.
The clock stops during the procedure. When you complete
the procedure, it restarts using the new settings.
To set the clock:
Action Notes
1.
Repeatedly press
Mode
until you see the
display for Setup mode.
The display shows:
EXIT
SETUP MENU
1–Scan
2–Call
ENTER
3–Config
4–More
1/2
2.
Enter 411
numeral
button
The clock stops running.
Example of the display:
EXIT
TIME SETUP
16:01 D/M/Y 03/05/97
ENTER
Enter hours

Codan HF SSB Specifications

General

Brand	Codan
Model	HF SSB
Category	Transceiver
Language	English