Codan HF SSB - Connecting ancillary equipment

Appendix
11-8 HF SSB transceiver reference manual
Connecting ancillary equipment
The following ancillary equipment plugs into the rear panel
of the transceiver:
• 8571 Remote control interface
• 9300 ALE controller
• 9366 or 9330 control head
• automatic antenna and antenna tuner
• computer
• data and fax modem
• external alarm
• GPS receiver
• IPC-500 telephone interconnect.
The following table shows the connections on the transceiver
rear panel for ancillary equipment.
Equipment connected to either the
RS-232
socket or
GP
connector on the transceiver rear panel is controlled by the
transceiver’s RS-232 and baud rate settings. See Chapter 7,
RS-232 connected equipment and RS-232 connection baud
rate.
If you want to connect a combination of ALE controllers,
computers and GPS receivers, you will need to use the
optional RS-232/I
2
C Interface described on page 11-10.
Appendix
11-8 HF SSB transceiver reference manual
Connecting ancillary equipment
The following ancillary equipment plugs into the rear panel
of the transceiver:
• 8571 Remote control interface
• 9300 ALE controller
• 9366 or 9330 control head
• automatic antenna and antenna tuner
• computer
• data and fax modem
• external alarm
• GPS receiver
• IPC-500 telephone interconnect.
The following table shows the connections on the transceiver
rear panel for ancillary equipment.
Equipment connected to either the
RS-232
socket or
GP
connector on the transceiver rear panel is controlled by the
transceiver’s RS-232 and baud rate settings. See Chapter 7,
RS-232 connected equipment and RS-232 connection baud
rate.
If you want to connect a combination of ALE controllers,
computers and GPS receivers, you will need to use the
optional RS-232/I
2
C Interface described on page 11-10.