Installation
2-4 HF SSB transceiver reference manual
Where cables must pass through bulkheads with sharp edges,
the insulation of the cables should be protected by grommets.
Holes in the bulkhead need only be large enough to allow the
end of the cable with the smaller connector to pass through
(for example, the control cable between the control head and
the transceiver).
If the power and control cables are long and follow a
common path, keep the cables separated by a minimum
of 200mm. The cables can be closer together for short
distances, for example, to pass through the same hole in
the bulkhead.
Failure to observe this warning will cause distortion of
the transmitted audio signals.
Installation
2-4 HF SSB transceiver reference manual
Where cables must pass through bulkheads with sharp edges,
the insulation of the cables should be protected by grommets.
Holes in the bulkhead need only be large enough to allow the
end of the cable with the smaller connector to pass through
(for example, the control cable between the control head and
the transceiver).
If the power and control cables are long and follow a
common path, keep the cables separated by a minimum
of 200mm. The cables can be closer together for short
distances, for example, to pass through the same hole in
the bulkhead.
Failure to observe this warning will cause distortion of
the transmitted audio signals.
To Next Page
Loading...
