InteliLite
NT
AMF26-P, SW version 2.4, ©ComAp – January 2016 124
AMF26-P-2.4 Reference Guide.pdf
Init Screens
Each InteliLite NT AMF26-P controller holds information about serial number, uploaded firmware
version and other information. This information is displayed on so called “Info Screen”. It is possible to
call this screen together with other useful screens from any measurement screen by pressing ENTER
and PAGE button concurrently. Then you can press just PAGE button to navigate through following
screens.
Init Screen
This is a first screen which is dedicated for informations provided by customers such as contact
numbers, service technician contact and customer message for end users of gen-set. Configuration of
this screen is only done through LiteEdit PC software, where Init Screen may be disabled.
Info Screen
This screen consists of information about type of controller, controller manufacturer (ComAp),
uploaded firmware branch, used ESF and currently configured electronic engine, firmware version,
application type and branche.
Details about configured electronic engine are in the chapter Identifying configured ECU.
Language Screen
IL-NT controller offers configurable language support. On this screen it is possible to switch between
languages configured in the controller.
Another option how to switch between configured languages is using binary input LANG SELECTION.
User Interface Screen
InteliLite NT controller enables to choose the user interface as customer prefers. There are two
choices available: USER or ENGINEER interface.
USER interface is ment for customers, who prefer simple and easy menu and don’t wish to list in
complex menu or change the settings of controller. In USER interface controller displays measuring,
alarm and init screens.
ENGINEER interface is dedicated for engineers and allow changing the settings of controller,
reviewing the history, measurement, alarms and grant the full access to all controllers screens with are
available. This mode is default.
Changing the mode of User Interface is possible from default measuring screen of controller by
simultaneous pressing the ENTER and PAGE button and than press again PAGE. On screen will be
displayed the choice of two different User Interfaces.
Last value displeyed on screen is DiagData, which is internal ComAp information in case of FW or unit
problems, which helps ComAp to analyze the root cause and find a proper solution.
You can see more in next chapter Operator Interface AMF under Controller Information Screen.
To Next Page
Loading...
