InteliLite
NT
AMF26-P, SW version 2.4, ©ComAp – January 2016 7
AMF26-P-2.4 Reference Guide.pdf
General Description
Description of the controller system (with all options)
InteliLite
NT
AMF26-P is a comprehensive AMF-controller for single generating sets operating in
stand-by mode. IL-NT AMF26-P features extended support of electronic engines and extension
modules.
InteliLite
NT
controllers are equipped with a powerful graphic display showing icons, symbols and bar-
graphs for intuitive operation, which sets, together with high functionality, new standards in Gen-set
controls.
InteliLite
NT
automatically starts the Gen-set, closes the Gen-set C.B. when all conditions are met, then
stops the engine on external signal or by pressing push buttons.
InteliLite
NT
provides gas engine support without ventilation.
The key feature of InteliLite
NT
is its easy-to-use operation and installation. Predefined configurations
for typical applications are available as well as user-defined configurations for special applications.
What is in the package?
InteliLite
NT
central unit
RS232 and RS485 communication card
Service USB communication card
Ethernet communication card
Gauge driver plug-in card
Earth Fault Current Protection Module
Earth Fault Current Protection Module
Internet communication bridge
Service programming RS232 interface
Serial RS232 communication cable 1,8m
*Remote display for IL-NT controllers uses standard IL-NT controller with Remote display software.
**Supported from version IL-NT-AMF26-P-2.0.
*** Supported from version IL-NT AMF 26-P- 2.2
Hint:
For detailed information about extension modules used with IL-NT controllers, please see the IL-NT-
Accessory Modules manual.
IL-NT RS232 Communication module
To Next Page
Loading...
