InteliLite
NT
AMF26-P, SW version 2.4, ©ComAp – January 2016 148
AMF26-P-2.4 Reference Guide.pdf
Recommended ISDN modem
x Askey TAS-200E
x ASUScom TA-220ST
x Develo Microlink ISDN i
Recommended GSM modem
x Siemens M20, TC35, TC35i, ES75, MC39
x Wavecom M1200/WMOD2
x Wavecom – Maestro 20, dual 900/1800MHz.
x Wavecom – Fastrack M1306B, dual 900/1800 MHz (Fastrack M1206B is NOT recommended)
x Wavecom – Fastrack Supreme 10
x FALCOM A2D, dual 900/1800MHz.
GSM Modem setup
Prior to start work with GSM modem run following program for GSM proper setup.
Program writes all the necessary AT commands to configure the GSM modem properly for use with IL-
NT.
This program runs independent on LiteEdit:
x Start MS Windows-Start-Program files - LiteEdit –Gm_setup.exe.
x Select COM port
x Select iG-CU (=IS-CU) or iG-MU unit
x Press Setup button
x Follow commands in GSM Modem Setup window
Typical real baud rate for GSM data communication is 80 to 90 Bps.
Hint:
It is strongly recommended to use the same type of modem on the both sides (IL and PC) of
connection.
Mobile SIM card setting
x Adjust SIM card in GSM modem following way:
x enable data connection (when required)
x no PIN code
Short guide how to start using IL-NT-GPRS module
CAUTION!
Any manipulation with plug-in module shall be done with disconnected power supply to both
controller and module!!! Otherwiese there is a risk of demanging the communication module.Power
supply shall be switched on also is same time to both module and controller. Fail to follow these
instructions (power supply active only in controller or only in module) can lead to module or controller
failure!
To Next Page
Loading...
