InteliLite
NT
AMF26-P, SW version 2.4, ©ComAp – January 2016 15
AMF26-P-2.4 Reference Guide.pdf
InternetBridge NT
InternetBridgeNT is a communication module that allows connection of a single controller as well as
whole site to the Internet or Local area network. The connection to the Internet can be via built-in
cellular modem supporting 2G and 3G networks or Ethernet cable.
Supported functions for InteliLite AMF26P, AC-03
ComAp Direct or AirGate connection (ComAp PC tools, WebSupervisor)
Active e-mails and Event e-mails only.
Supported connection modes: RS232 or RS485
.
IL-NT-GPRS GSM and GPRS plug-in modem
CAUTION!:
Any manipulation with plug-in module shall be done with disconnected power supply to both controller
and module. Power supply shall be switched on also is same time to both module and controller. Fail
to follow these instructions (power supply active only in controller or only in module) can lead to
module or controller failure!
IL-NT-GPRS is a modem plug-in module which support GPRS internet connection and also dial up
connection. This module incorporates support of AirGate technology for plug and play connection via
GPRS. Module is usually used for connection to remote monitoring and controlling systém.
WebSupervisor (http://websupervisor.comap.cz) or to LiteEdit PC software. Module is capable of
sending alarm SMS based on settings in SMS/Email setpoint group.
Hint:
Quick guide how to start using this module is in chapter Remote Communication - Short guide how to
start using IL-NT-GPRS module or on ComAp webpage http://www.comap.cz/products/detail/IL-NT-
GPRS.
IL-NT-AOUT8 Gauge driver module
IL-NT-AOUT8 is optional plug-in card. Through this card controller can drive up to 8 VDO style
industrial/automotive gauges. Noncompensated gauges like 0-10V or 0-20mA are not supported.
Gauge type and value are configured in LiteEdit software. Any analog value from controller may be
shown in that way.
To insert the module, you must open the cover first (use screwdriver to open) and then insert the
module into slot. Once you have insert it, the module will snap under plastic teeth. It is supposed to be
installed permanently. Should you need to remove it, the safest way is to remove whole back cover
and than remove module manually.
To Next Page
Loading...
