ComAp InteliLite NT AMF26-P - General Guidelines; What Describes this Manual; Important Safety Instructions; Warnings

InteliLite
NT
AMF26-P, SW version 2.4, ©ComAp – January 2016 5
AMF26-P-2.4 Reference Guide.pdf
General Guidelines
What describes this manual?
! IMPORTANT SAFETY INSTRUCTIONS !
SAVE THESE INSTRUCTION - This manual contains important instructions for IL-NTAMF26- P
controller that shall be followed during installation and maintenance of the InteliLite NT genset
controllers. It is intended for use by gen-set control panel builders and for everybody who is
concerned with installation, operation and maintenance of the gen-set.
This manual describes „AMF26-P“ software, which is designed for single set, stand-by applications.
What is the purpose of the manual?
Manual also provides general information how to install and operate InteliLite NT AMF26-P controller.
This manual is dedicated for
Operators of gen-sets
Gen-set control panel builders
For everybody who is concerned with installation, operation and maintenance of the gen-set
!! Warnings !!
Remote control
IL-NT controller can be remotely controlled. In case of the work on the gen-set check, that nobody
can remotely start the engine.
To be sure:
Disconnect remote control via RS232 line
Disconnect input REM START/STOP
or
Disconnect output STARTER and outputs GCB CLOSE/OPEN and MCB CLOSE/OPEN
Because of large variety of InteliLite
NT
parameters settings, it is not possible to describe any
combination. Some of IL-NT functions are subject of changes depend on SW version. The data in this
manual only describes the product and are not warranty of performance or characteristic.
Symbols
Symbols used in this manual:
Grounding
point symbol
AC voltage
symbol
DC voltage
symbol
Text
PAGE (Capital letters in the frame) buttons on the front panel