InteliLite
NT
AMF26-P, SW version 2.4, ©ComAp – January 2016 74
AMF26-P-2.4 Reference Guide.pdf
SMTP User Pass [-]
Use this setpoint to enter the password for the SMTP server. User password of e-mail account for
verification of e-mail sender on SMTP server. If parameter left empty, no verification is expected.
Hint:
Works for IB-Lite only.
SMTP Server IP [-]
This setpoint is used for entering the domain name (e.g. smtp.yourprovider.com) or IP address (e.g.
74.125.39.109 of the SMTP server. Please ask your internet provider or IT manager for this
information.
Hint:
You may also use one of free SMTP servers, e.g. smtp.gmail.com. However, please note that some
free SMTP servers may cause delays (in hours..) when sending e-mails.If you do not want to send
active e-mails, you may leave this setpoint blank, as well as other setpoints related to SMTP server
and e-mail settings.Proper setting of SMTP-related setpoints as well as controller mailbox are
essential for sending alerts via e-mails.
Hint:
IP address of SMTP server. Works for IB-Lite only.
Contr Mail Box [-]
Enter an existing e-mail address into this setpoint. This address will be used as sender address in
active e-mails that will be sent from the controller.
Time Zone [-]
This setpoint is used to select the time zone where the controller is located. See your computer time
zone setting (click on the time indicator located in the rightmost position of the the windows task bar) if
you are not sure about your time zone.
Hint:
If the time zone is not selected properly the active e-mails may contain incorrect information about
sending time, which may result in confusion when the respective problem actually occured.
DNS IP Address [-]
If DHCP is DISABLED this setpoint is used to adjust the domain name server (DNS), which is needed
to traslate domain names in e-mail addresses and server names into correct IP addresses.
If DHCP is ENABLED this setpoint is used to display DNS server, which has been assigned by the
DHCP server.
Engine Params
Starting RPM [%]
“Firing” speed when IL controller stops cranking (starter goes OFF).
Step: 1% of nominal RPM
Range: 5 – 50 %
Starting Oil P [Bar]
When reached controller stops cranking (starter goes OFF).
Step: 0,1 bar
Range: 0,0 – 10,0
To Next Page
Loading...
